Summary:
Published 2026 cost guides put light fixture installation at about $100 to $650 with the fixture included (HomeGuide, $400 national average). Labor alone runs $50 to $250 to replace a fixture on existing wiring and $250 to $600 where new wiring is needed. HomeAdvisor’s national average is $589 with a typical range of $158 to $1,020, because it includes more chandelier and high-end jobs. A flush-mount ceiling light is the cheap end ($70 to $250 installed), a chandelier the expensive end ($220 to $3,400). These are national ranges for budgeting, not a quote.
Swapping a dated ceiling light for a new one is one of the quickest ways to change a room, and in most cases it is a short visit for an electrician. The price moves when the new fixture is heavy, the ceiling is high, there is no fixture there now, or the old wiring turns out to be a surprise.
This guide lays out what the national cost guides say light fixture installation costs in 2026, by fixture type and by job type, and what to check before you buy the fixture. Hooked Up Electric is a licensed Texas electrical contractor with offices in Abilene, San Angelo, Midland, and Lubbock. The prices below are published ranges to help you budget. For a real number, call and tell us about the fixture and the room.
Light Fixture Installation Cost at a Glance (2026)
Typical prices from published national cost guides.
| Item | Published range | Source |
|---|---|---|
| Light fixture installed (all types) | $100 to $650, average $400 | HomeGuide |
| Light fixture installed (all types) | $158 to $1,020, average $589 | HomeAdvisor |
| Labor, replacing a fixture on existing wiring | $50 to $250 | HomeGuide |
| Labor, new fixture with new wiring | $250 to $600 | HomeGuide |
| Flush-mount ceiling light, installed | $70 to $250 | HomeGuide, HomeAdvisor |
| Pendant, installed | $100 to $300 | HomeGuide, HomeAdvisor |
| Wall-mounted light (sconce), installed | $100 to $250 | HomeGuide, HomeAdvisor |
| Track lighting, installed | $100 to $300 | HomeGuide, HomeAdvisor |
| Recessed light, installed | $130 to $300 per light | HomeGuide, HomeAdvisor |
| Chandelier, installed | $220 to $3,400 and up | HomeGuide, HomeAdvisor |
| Under-cabinet light, installed | $200 to $500 per fixture | HomeAdvisor |
| Dimmer switch, installed | $80 to $200 | HomeGuide |
| Ceiling junction box | $100 to $300 | HomeGuide |
| Electrician hourly rate | $50 to $130 (HomeGuide); $50 to $100 (HomeAdvisor) | HomeGuide, HomeAdvisor |
| Service call fee | $100 to $200 | HomeGuide |
| Permit, where new wiring needs one | $30 to $50 | HomeGuide, HomeAdvisor |
| Time | 1 to 2 hours | HomeGuide |
Why the ranges differ: the fixture price is the wild card. The labor to hang a $40 flush mount and a $400 pendant on the same box is about the same; a 60-pound chandelier on a 14-foot ceiling is a different job with a lift, a rated box, and two people.
Replacing a Fixture vs. Adding One Where There Was Nothing
- Like-for-like replacement. The wiring, switch, and box are already there. The electrician removes the old fixture, checks the box and the wiring condition, mounts the new fixture, and tests it. This is the $50 to $250 labor case.
- New location. Cable has to be run from a switch or circuit to the new spot and a box installed in the ceiling or wall. HomeGuide lists $250 to $600 labor for new wiring plus $100 to $300 for the junction box. Attic access makes it routine; a slab home with no attic above, or a second floor over the room, means fishing cable.
- Heavy fixtures. A standard ceiling box is rated for a modest weight. Heavier chandeliers need a box rated for the load, or support straight to the framing. That is the same rule that applies to ceiling fans; our ceiling fan installation cost guide explains it.
- New switch or dimmer. A dimmer is $80 to $200 installed at HomeGuide. A new switch location is wiring work on top of that.
What Changes the Price in West Texas
- Ceiling height. Two-story entries and vaulted living rooms are common in newer homes around Abilene, Midland, and Lubbock. A fixture at 14 to 20 feet needs a lift or scaffold and usually two people, and the chain or cord has to be sized for the drop.
- Fixture weight. Large chandeliers and some modern multi-arm fixtures need a rated box or framing support.
- Old wiring. Older houses in San Angelo and central Abilene sometimes have brittle cloth-insulated wire or no ground at the ceiling box. The electrician may need to add a box, extend conductors, or recommend a larger repair. Our rewiring cost guide covers that.
- Bathroom and outdoor fixtures. Vanity lights near a tub or shower and exterior fixtures have location ratings (damp or wet) and often GFCI rules on the circuit.
- Assembly time. Some fixtures ship in a hundred pieces. Assembly is labor; have it done or budget for it.
- Permits. A replacement usually needs none. New wiring may, depending on the city, at $30 to $50 (HomeGuide, HomeAdvisor).
Fixtures outside the house have their own cost factors, so we cover them separately in our guide to outdoor lighting installation costs.
What a Light Fixture Installation Includes
On a typical visit a licensed electrician will turn off the circuit and verify it is dead, remove the old fixture, inspect the box, the wiring, and the mounting, install a rated box or brace if the new fixture needs one, assemble and hang the fixture, connect it with the correct grounding, install bulbs or confirm the LED module, and test the switch or dimmer. For a new location, add the cable run, the box, and any switch work. If you are also adding recessed lights or a fan in the same room, one visit is cheaper than two; see our recessed lighting cost guide and lighting installation page.
Choosing the Fixture
Buy it before the visit, and check three things on the box: the weight, the mounting type (does it need a fan-rated or heavy-duty box?), and whether it is dimmable if you plan a dimmer. For bathrooms and porches, check the damp or wet location rating. For a chandelier, measure the ceiling height and the drop you want before you order, because shortening a chain is easy and lengthening one is not. Energy Star and LED fixtures cost a little more upfront and far less to run; HomeGuide lists Energy Star fixtures at $60 to $600.
If the fixture is going in a bathroom, a combined fan and light unit is another option. See our guide to bathroom exhaust fan costs for what that kind of install usually involves.
How to Keep the Cost Down
- Have the fixture on site and assembled when the electrician arrives.
- Replace several fixtures in one visit. The service call fee is the same for one or five.
- Reuse the existing box and location when the new fixture allows it.
- Ask about the box before buying a heavy fixture so the right support is on the truck.
- Bundle other work. Our electrician cost guide explains how service calls are priced.
Frequently Asked Questions About Light Fixture Installation Costs
How much does an electrician charge to install a light fixture?
HomeGuide lists labor at $50 to $250 to replace a fixture on existing wiring and $250 to $600 with new wiring, with electricians charging $50 to $130 per hour and a $100 to $200 service call fee. Installed totals run $100 to $650 at HomeGuide and $158 to $1,020 at HomeAdvisor.
How much does it cost to install a chandelier?
HomeGuide and HomeAdvisor both list $220 to $3,400 and up installed, with the fixture itself making up most of that. Height and weight drive the labor.
Can I replace a light fixture myself?
Many people do swap a simple fixture, but the box, the grounding, and the wiring condition are what an electrician checks and a homeowner often cannot judge. Anything that needs a new box, new wiring, or a heavy support is a job for a licensed electrician.
Do I need a permit to replace a light fixture in Texas?
Usually not for a like-for-like replacement. New wiring may need one depending on the city, at $30 to $50 (HomeGuide, HomeAdvisor). A licensed electrician pulls it when required.
How long does it take?
HomeGuide lists 1 to 2 hours for a typical fixture. High ceilings, assembly, and new wiring add time.
What is the cheapest fixture to install?
A flush-mount or semi-flush ceiling light on an existing box: $70 to $250 installed at HomeGuide and HomeAdvisor.
Ready to update the lighting? Call 325-442-5594 or request a free quote. We work out of offices in Abilene, San Angelo, Midland, and Lubbock.
Sources: HomeGuide, light fixture installation cost (updated August 2025); HomeAdvisor, cost to replace a light fixture (updated June 2026).



